If you have access to an FDM printer, you can print the Wall Lamp yourself using the material of your choice.

 Recommended settings:
 Wall Loops: 2
 Infill density: 5-20% (the more infill, the heavier the lamp)
 Infill pattern: rectilinear or as desired
 Support material for overhangs
 Brim: 5-10mm

 I recommend a transparent filament PLA or PETG.
 Important: This lamp was designed for an E14 lamp socket,
 designed for an E14 LED 2.5 to 4w light bulb.

 Have fun printing!

 Matching textile cable and the corresponding E14 socket can be found here:

 https://www.stoffkabel.kaufen/Textilkabel-mit-Schalter-und-Flachstecker

 https://www.stoffkabel.kaufen/E14-Thermoplast-Fassung-schwarz-Glattmantel-mit-Zugentlaster-Kunststoff-schwarz

 With a note to the manufacturer that the cable and socket may already be professionally assembled.

 äm | äs | ka Design Studio and Martina Skvaro assume no liability for improper use of the products I offer, for the use of incorrectly inserted light bulbs, incorrectly inserted print materials, or for misprints. Only light bulbs that cannot get hotter than 40 degrees should be used. Please choose E14 LED light bulbs with 2.5-4.0 watts and a maximum of 400 lm. An E14 lamp socket should also be used for this lampshade. The light bulb must NOT touch the printed plastic! Always turn off lamps when leaving the house!

 By downloading this file, you agree not to resell the downloaded data. 3D prints made from this file may be used for private purposes and given away as gifts—but may not be resold under any circumstances.