This base was designed for the following socket: "AAi Mobile Light Fitting," available from Galaxus. I use a large-diameter LED opal bulb from Micasa (OPAQUE RA90 E27 max. 4.5W, diameter 12.5cm/G125 400lm). You can find this or similar models from various suppliers such as Micasa, Jumbo, or Manufactum.

 Material used: Silk PLA+

 Recommended settings:
 Wall Loops: 3
 Infill density: 10-15%
 Infill pattern: rectilinear or as desired
 No support material required


 äm | äs | ka Design Studio and Martina Skvaro assumes no liability for the improper use of the products I offer, for the use of incorrectly inserted light bulbs, incorrectly inserted print materials or for misprints. Only light bulbs that can NOT get hotter than 40 degrees should be used. Please choose E27 LED light bulbs up to max. 4.5 watts with a maximum of 400 lm . An E27 lamp socket should also be used for this base. The light bulb must NOT touch the printed plastic! Always turn off lamps when leaving the house!

 By downloading this file, you agree not to resell the downloaded data. 3D prints made from this file may be used for private purposes and given away as gifts—but may not be resold under any circumstances.

 Have fun printing!